This basic monitoring system for a single engine recreational fishing yacht will monitor the propulsion engine, 4 tanks, and 3 bilge compartments with all information displayed on a 5.7” sunlight readable display. If any of the monitored parameters go outside programmable limits, the display will flash and the buzzer will sound an alarm.
The following table shows the products included within this example system plus a list of the information or data available for display.
| Product | Description | Available Data List |
| DSM250 | Display | Displays data in this list, monitors the data and sounds an internal buzzer if there is a problem |
| ALM100 | Alarm buzzer | Sounds a loud buzzer when any monitored data in this list goes outside programmed limit |
| J2K100 | Engine Monitor | Monitors RPM, boost and oil pressure, oil and coolant temp, voltage, fuel rate, hours |
| FPM100 | Tank Monitor | Monitors levels in 2 fuel tanks, 2 fresh water tanks, 1 black water and 1 gray water tanks |
| SIM100 | Switch indicator | 3 high bilge water indicators, magnetic door switch, smoke/heat detector, CO detector |
| RIM100 | Run indicator | Monitors 3 bilge pumps for breaker status and pump run status, counts and times pump runs |
This file requires Maretrons free NMEA 2000® network design tool N2KBuilder® to be installed on your PC.
The following screenshots are examples of how monitored data can be displayed on the DSM250.
Engine Battery
Engine Coolant and Oil
Engine Fuel Rate
Engine Hours
Engine Pressures and Load
Engine Tachometer Gauge
Fresh Water Tank Gauges
Fuel Gauge
Fuel Gauges
Fuel Remaining Total and Tanks
Gray and Black Water Tank Gauges
Run Counter and Timer
Run Indicators Off
Run Indicators On
Switch Indicators Off
Switch Indicators Off Color
Switch Indicators On
Switch Indicators On Color
Total Fuel Gauge
