- Products
- Suggested Systems
Suggested Systems
- ACM100 - Alternating Current Monitor
- DCM100 - Direct Current Monitor
- FFM100 - Fluid Flow Monitor
- FPM100 - Fluid Pressure Monitor
- GPS200 - Antenna/Receiver
- J2K100 - J1939 to NMEA 2000 Gateway
- NBE100 - Network Bus Extender
- RAA100 - Rudder Angle Adapter
- SSC300 - Solid State Compass
- SMS100 - Text Messaging
- Support
Support & Downloads
Warranty
Tools
Remote Support
Need help?
- Company
WSO100
Ultrasonic wind and weather station
Discontinued
Winner of a 2007 Sail Magazine Pittman Innovation Award!
* Configuration of certain parameters are made much easier using Maretron DSM250, USB100, or IPG100
Maretron's outdoor weather station measures wind speed and direction, air temperature, barometric pressure, and relative humidity. The wind measurement is performed using ultrasonic sensors, which means there are no moving parts to wear out or to get caught in the rigging.
The WSO100 accurately measures wind speed and direction under tilt of up to 30°, making it ideal for sail as well as power conditions.
When used with Maretron's SSC300 compass and a display such as Maretron's N2KView® vessel monitoring system, or Maretron's DSM250 color graphics displays, the user will be able to view both apparent and true wind speed and direction as well as dew point and wind chill factor.
The WSO100 mounts on a 1"-14 Standard Marine Mount
- Apparent wind speed
- Apparent wind direction
- Atmospheric pressure
- Air temperature
- Relative humidity
Note: Maretron monitoring sensors are updated using Maretron’s N2KAnalyzer application on a PC paired with an approved NMEA 2000® gateway.
2.0.13 (2009-10-27) – Current Release
- Change LEN to 3 (150mA) (LEN used to be 7 (350mA) for heater)
- Change humidity sensor time base to 400 ns (allow wider range for sensor wet detection)
- Add wet sensor detection (too hi cap.) (DSM display 100%RH)
- Add bad sensor detection (too low cap.) (DSM display “-“)
2.0.12 (2009-02-12)
- Support Maretron Label Protocol #2
- Support Maretron Channel Protocol #2
- Transmit 130312 as default
- Transmit 130313 as default
- Transmit 130314 as default
- Support variable rate of periodic TX PGN
2.0.11 (2008-03-03)
- Transmit 130310 as default
- Fix problem when device try to transmit PGN while the device has no node address which cause n2k stack full
- support boot version inquiry
- support firmware info data structure
- support EEPROM data structure
2.0.10 (2007-11-29)
- Add fixed sf and os to temperature reading
- Start supporting source file information
2.0.9 (2007-04-10)
- Support WSO100 PCB HW 2.0
- Support WSO100 PCB HW 1.0
1.0.8 (2007-01-05)
- Support env calibration program
- Support heater for pressure sensor
- Support basic AGC at low temperature
1.0.7 (2006-10-17)
- Support OEM Setting
- Fixed bug for channel 1 did not use wpulse cal data
1.0.6 (2006-06-01)
- Initial Public Release



