DSM250 (Discontinued)

A standard Maretron NMEA2000 navigation sensor network consists of the following components: Compass: SSC200 GPS: GPS200 Depth Speed Water: DST110 Weather: WSO100 Display: DSM150 System Capabilities: Wind Apparent Speed over ground Course... Read More

The FFM100 can update your existing NMEA2000 network to include engine fuel rate. Several components are needed to offer you calculative information for Fuel management such as distance to empty, time to empty, and fuel consumption, to name a few.... Read More

 The TLM100 uses an ultrasonic signal to determine a distance measurement from sensor to level. The tank application must be compatible with the TLMXXX measurement technology. If you have already installed a TLMXXX and received unexpected... Read More

NOTE: The EMS100 has been discontinued and is no longer offered for sale. There are several ways to view Yanmar engine information over an NMEA 2000 network, one of which is using the Maretron dedicated color display (DSM250). The following diagram... Read More

NOTE: The EMS100 has been discontinued and is no longer offered for sale. To configure the EMS100 using the DSM250, start from the favorite screen mode and press the enter key or the far right hand button, scroll to configuration and press enter,... Read More

NOTE: The EMS100 has been discontinued and is no longer offered for sale. The EMS100 is suitable to work with Yanmar Engines which carry the Yazaki type connector. If your engine comes with a Yanmar panel, please note that all panels are not... Read More

NMEA 2000 allows multiple devices of the same type to be connected on a network at one time. The "Instance:" menu item allows you to choose a particular device for display on the DSM150 or DSM250. For example, if there were two GPS antennas on the... Read More

The RAA100 default calibration mode is set to accept the American standard resistance values of 240 to 30 ohms (240 ohms representing 60 degrees to port and 30 ohms representing 60 degrees to starboard). This can be changed using Maretron's DSM150,... Read More

In order to keep the number of Maretron DSM150, DSM200, and DSM250 display menu items to a minimum (there is a possibility of more than 250 batteries, more than 250 engines, more than 250 rudders, etc.), the displays default to only a single rudder.... Read More

Maretron's DSM150, DSM200,and DSM250 displays have a J2K100 configuration setting called "Reset Factory Defaults" which is used to return the J2K100 to its factory settings. Resetting the J2K100 to factory defaults sets the J1939 source address back... Read More