DSM200(Discontinued)

Occasionally, a device can be in "boot mode" (represented in N2KAnalyzer by an orange highlight of the device's entry in the device list). This can happen due to a software update which fails due to network problems. A Maretron device that is ... Read More

The Maretron Capability Matrix helps highlight the system features available for display when designing a system within N2KBuilder.  To generate a system capability Matrix within N2KBuilder simply click on Tools, "Create Maretron Capability... Read More

Maretron Model Device Description NMEA2000 Operating Voltage Engine/Battery Interface CLM100 P/N: M000070  Current Loop Monitor 9 to 32 Volts   SSC200 P/N: M000001, M000021, M000022 NMEA 2000 Solid State Compass HW 1.0 9 to 16 Volts  ... Read More

A standard Maretron NMEA2000 navigation sensor network consists of the following components: Compass: SSC200 GPS: GPS200 Depth Speed Water: DST110 Weather: WSO100 Display: DSM150 System Capabilities: Wind Apparent Speed over ground Course... Read More

Maretron's DSM150, DSM200,and DSM250 displays have a J2K100 configuration setting called "Reset Factory Defaults" which is used to return the J2K100 to its factory settings. Resetting the J2K100 to factory defaults sets the J1939 source address back... Read More

Maretron's DSM150, DSM200,and DSM250 displays have a J2K100 configuration setting called "NMEA 2000 PGN Enable/Disable?" which is used to turn on and off specific messages that are transmitted by the J2K100. Read More

Maretron's DSM150, DSM200,and DSM250 displays have a J2K100 configuration setting called "J1939 Diagnostic Messages:"  which is used to configure the J2K100 to pass diagnostic messages from the J1939 network through to the NMEA 2000 network.... Read More

You display the J2K100 tachometer on a DSM150, DSM200, or DSM250 in the following way. Enter menu mode, scroll to "Favorite Screen Setup..." and press Scroll to the favorite screen where you would like to view the tachometer and press Scroll to ... Read More

You display UTC from the GPS100 on a DSM150, DSM200, or DSM250 in the following way: Enter menu mode (press the key or far right button), scroll to "Favorite Screen Setup..." and press  Scroll to the favorite screen where you would like to view... Read More

You display the TLA100 tank capacity on a DSM150, DSM200, or DSM250 in the following way: Enter menu mode, scroll to "Favorite Screen Setup..." and press Scroll to the favorite screen where you would like to view the tank capacity and press Scroll... Read More