MBB300C

Maretron announces the release of version 6.4.1 of the N2KView® V3 software. The Computer (PC & MAC) version of N2KView is available via the following link https://www.maretron.com/products/n2kview-vessel-monitoring-and-control-software/#lqd-tab... Read More

Yes! You are able to receive an email message in response to an alert status from a device running N2KView. * This requires the transmitting device (Computer, MBB or TSM) to have internet access and an active email account in order to transmit the... Read More

Maretron's MBB300C can be used as a web server that can stream the N2KView application via HTML5, an interactive Web Service, through a LAN (Ethernet) connection. Many 3rd Party vendors label this service slightly different, but all referring to the... Read More

Does Maretron N2KView V3 software support Hatteland Seahawk series camera? Yes!! Please apply the following settings to each of your Hatteland Seahawk series cameras to support video output display on devices running N2KView V3 running version 6.3.0... Read More

N2KView is designed to display data from IP cameras produced by AXIS Communications, with the exception of the "Companion Series", that provide: Video Stream Motion jpg (mjpg) video format VAPIX interface Anonymous Login Viewing Enabled- If you want... Read More

  Within this article outlines a basic setup guideline for integrating your AXIS camera or AXIS encoder that is connected to the same LAN as your device running N2KView (TSM, MBB, and/or computer).   Access your AXIS camera via your browser... Read More

Maretron has partnered with Garmin® in order to introduce the N2KView® platform as a Garmin OneHelm® service. This will allow a single Maretron Black Box computer, such as the MBB300C, to populate the highly customizable N2KView Vessel... Read More

Saving a N2KView config file to a USB device. 1. Insert a USB flash drive into an available USB port on your device. 2. From the main screen, tap to reveal the available tabs and select Commands and Settings on the right. 3. Select tab labeled... Read More

DCR100 channels have two possible operating modes: “Normal”, in which the DCR100 channel responds to standard NMEA 2000 switching commands, and “Annunciator”, in which the channel may be connected to a power source for a... Read More

If you have set the camera configuration and video still does not appear, please do the following: Confirm the PC or Maretron Display is connected to the LAN network a camera is installed.  Run the Axis Camera Setup tool and confirm that the... Read More