Maretron announces the release of version 6.4.1 of the N2KView® V3 software. The Computer (PC & MAC) version of N2KView is available via the following link https://www.maretron.com/products/n2kview-vessel-monitoring-and-control-software/#lqd-tab... Read More
Yes! You are able to receive an email message in response to an alert status from a device running N2KView. * This requires the transmitting device (Computer, MBB or TSM) to have internet access and an active email account in order to transmit the... Read More
Does Maretron N2KView V3 software support Hatteland Seahawk series camera? Yes!! Please apply the following settings to each of your Hatteland Seahawk series cameras to support video output display on devices running N2KView V3 running version 6.3.0... Read More
N2KView is designed to display data from IP cameras produced by AXIS Communications, with the exception of the "Companion Series", that provide: Video Stream Motion jpg (mjpg) video format VAPIX interface Anonymous Login Viewing Enabled- If you want... Read More
Within this article outlines a basic setup guideline for integrating your AXIS camera or AXIS encoder that is connected to the same LAN as your device running N2KView (TSM, MBB, and/or computer). Access your AXIS camera via your browser... Read More
Saving a N2KView config file to a USB device. 1. Insert a USB flash drive into an available USB port on your device. 2. From the main screen, tap to reveal the available tabs and select Commands and Settings on the right. 3. Select tab labeled... Read More
May 24, 2018
0
0
1407
0/5 (0 Vote)
2/10/2019 - initial Release
Read More
TSM810C