DSM410

The prerequisite for using this guide requires the use of a Windows PC and Maretron's N2KAnalyzer program installed. The hardware required for Maretron device configuration is the USB100 or IPG100 Gateway connected to a... Read More

What firmware changes have taken place on the Maretron DSM410 display? Update your device using the N2KAnalyzer software tool.   1.9.1.2 (2024-05-08) Add support for DSM410v2 (HW 3.0) Add SPN selection to J2K100 configuration Add support for SMS200... Read More

Now that you have configured your DSM Display just the way you want it. Once complete you can backup all your work using the following method:  You must have several items prepared on the NMEA 2000 network in addition to your Windows PC to begin: ... Read More

The DSM250 supports the display of information for up to sixteen tanks types (16 fuel plus 16 water,etc.).Tank sub-categories include:Capacity – displays the fluid capacity of the tankLevel – displays the level of fluid in the tank as a... Read More

Does Maretron offer a DSM410 Gimbal mount? No, Maretron does not sell a DSM410 gimble mount. However, we do provide a 3D printer "STL" file (located in the attachment section below) that allows a 3D printer program to make the hardware on a 3D... Read More

Yes, The DCR100 can control your audio amplifier by way of the “Remote” input to the amplifier. For vessels with large audio networks an N2KView user can use this feature to selectively control audio amplifiers by way of a single or... Read More

Occasionally, a device can be in "boot mode" (represented in N2KAnalyzer by an orange highlight of the device's entry in the device list). This can happen due to a software update which fails due to network problems. A Maretron device that is ... Read More

DCR100 channels have two possible operating modes: “Normal”, in which the DCR100 channel responds to standard NMEA 2000 switching commands, and “Annunciator”, in which the channel may be connected to a power source for a... Read More

  For a printable DSM410 mounting template, download the PDF under the attachments section below.    Read More

You display temperature from a TMP100 using the DSM250 in the following way. Enter menu mode (press the enter or far right hand button), scroll to "Favorite Screen Setup…" and press enter. Scroll to the favorite screen where you would like to... Read More