What firmware changes have taken place on the Maretron DSM410?

What firmware changes have taken place on the Maretron DSM410 display?

Update your device using the N2KAnalyzer software tool.

1.9.1.2 (2024-05-08)

1.8.8.4 (2023-06-30)

Add new fluid types string based on NMEA AT20220802, (DSM570SW-4)
Add keypad lock mode, (DSM570SW-5)
Add keypad sensitivity setting, (DSM570SW-5)
Allow the maximum of two simultaneous keys pressed. If multiple touches were detected, key press action will be skipped to reduce effect of water stream, (DSM570SW-5)
Add configuration support for Airmar DST810, (DSM570SW-1)
Change beep time base to 20ms
Enable beep sound only on active buttons

1.8.7.1 (2022-09-08)

1.8.6.3 (2022-03-16)

Fix rolling toad trail issue on VGA resolution display
Correct Demo icon position on VGA resolution display
Change screen lock mode selection from buttons combination on power up to power down options selections
Add testmode command "startup" to support startup options
Fix rolling road crash when ellipse cannot be drawn
Correct DCM menu display text GEL

1.8.5.2 (2021-10-07) - Not Released

In power off state, keep internal power supply active if N2K supply voltage is less than 10V

1.8.4.6 (2021-04-21)

1.8.3.2 (2020-08-14)

Support TSM810C, TSM1210C, MBB300C configuration
For FFM100 configuration menu, always display K-Factor as 1000 when the K-Factor on FFM100 is 1000. This fix an issue caused after load default to FFM100 and the DSM display the old K-Factor value before loading default, this issue also fixed in the FFM100 SW 1.4.1.1
Support CLM100 SW 1.2+
Support CLM100 configuration for Battery, Engine, Transmission, and Vessel Devices

1.8.1.2 (2018-10-15)