Device Configuration Using DSM250

The prerequisite for using this guide requires the use of a Windows PC and Maretron's N2KAnalyzer program installed. The hardware required for Maretron device configuration is the USB100 or IPG100 Gateway connected to a... Read More

Use the N2KAnalyzer software program or a Maretron DSM150, or Maretron DSM250 to perform Maretron Device level configuration. This article will show methods for configuring the TMP100 Using Maretron's N2KAnalyzer software tool.   Pre... Read More

Maretron's Switch Indicator Module monitors dry contacts. Once you have selected the dry contact device, connect the two leads from the device to one of six SIM100 channels. Each channel has two terminals; for example, Channel #0 uses... Read More

... Read More

NOTE: The EMS100 has been discontinued and is no longer offered for sale. To configure the EMS100 using the DSM250, start from the favorite screen mode and press the enter key or the far right hand button, scroll to configuration and press enter,... Read More

The procedure for testing an ALM100 can be performed using the following Maretron User Interface products: DSM150/DSM250: Go to Main Menu-->Scroll to Configuration-->Select "Device Configuration"-->Select the ALM00 you wish to test-->Scroll to "Test... Read More

Yes, you can use a DSM150 or  DSM250 to configure a DCR100. Please watch the following video to see how it's done.      Read More

To perform a cold start on the GPS100 using the Maretron DSM150, DSM200, or DSM250 display. Enter menu mode, scroll to "Configuration..." and press enter. Scroll to "Device Configuration..." and press enter. Scroll to the GPS100 and press enter.... Read More

In order to setup an EMS100 several things must be known. What senders have been installed on the engine? What type of engine gauge panel is installed with the engine? Where is the factory interface available for the EMS100 engine harness to tee into... Read More

To set a "Device Instance" for a Maretron sensor using the DSM250, simply press the enter key (far right hand button) to view the "Menu Mode", scroll to "Configuration", hit enter, select "Device Configuration", hit enter, scroll to the desired... Read More