Maretron Model Device Description NMEA2000 Operating Voltage Engine/Battery Interface CLM100 P/N: M000070 Current Loop Monitor 9 to 32 Volts SSC200 P/N: M000001, M000021, M000022 NMEA 2000 Solid State Compass HW 1.0 9 to 16 Volts ... Read More
DSM250 (Discontinued)
Knowledge base Article 578 showed how to do comprehensive bilge monitoring using Maretron's Run Indicator Module (RIM100) and a Switch Indicator Module (SIM100). This article shows how the monitored information from article 578 can be displayed on... Read More
The SMS100 Status Message is a text message you can receive from the SMS100 containing key pieces of information regarding your vessel. When the SMS100 is installed, you can text the word "Status" to your SMS100 cellular number ... Read More
The ALM100 can be commanded to annunciate by way of Maretron Displays(excluding legacy DSM200) or PC software N2KView(alerts enabled) only. Third-Party devices, Chart-plotters, and MFDs are not compatible to with the ALM100. Read More
Maretron's Switch Indicator Module monitors dry contacts. Once you have selected the dry contact device, connect the two leads from the device to one of six SIM100 channels. Each channel has two terminals; for example, Channel #0 uses... Read More
Yes, the FPM100 can transmit vacuum pressure data on the NMEA2000 bus by using Maretron sensor part number PT-V-0-1BAR-01. This sensor must be installed on the vacuum side of your fuel filter to help you determine fuel... Read More
The J2K100 is capable of transmitting the following information: PGN 65030 AC Generator Current AC Generator Frequency AC Generator Voltage Engine parameters 127488, 127489 Tachometer Engine Hours Coolant Pressure Coolant Water Temperature... Read More
The TMP100 is capable of transmitting the following information: Sea Temperature Outside Temperature Inside Temperature Engine Room Temperature Main Cabin Temperature Live Well Temperature Bait Well Temperature Refrigeration Temperature Heating... Read More
SMS100 Operational Requirements: Working NMEA2000 network SMS100 text module DSM150/DSM250 display with firmware version 1.4.18.8 or higher N2KView software/hardware versions 3.6.2 or higher The SMS100 requires a Maretron display to... Read More
Knowldege base article 578 showed how to do simple bilge monitoring using Maretron's Run Indicator Module (RIM100). This article shows how the monitored information from article 578 can be displayed on Maretron's DSM150 and DSM250 displays. The left... Read More
Results
11 -
20 of
166