DSM250 (Discontinued)

Maretron's DSM150, DSM200,and DSM250 displays have a J2K100 configuration setting called "NMEA 2000 PGN Enable/Disable?" which is used to turn on and off specific messages that are transmitted by the J2K100. Read More

Maretron's DSM150, DSM200,and DSM250 displays have a J2K100 configuration setting called "J1939 Diagnostic Messages:"  which is used to configure the J2K100 to pass diagnostic messages from the J1939 network through to the NMEA 2000 network.... Read More

You display the J2K100 tachometer on a DSM150, DSM200, or DSM250 in the following way. Enter menu mode, scroll to "Favorite Screen Setup..." and press Scroll to the favorite screen where you would like to view the tachometer and press Scroll to ... Read More

You reset the DST100 trip log using a DSM150, DSM200, or DSM250 in the following way. Enter the menu mode, scroll to "Configuration..." and press Scroll to "Device Configuration..." and press Scroll to the DST100 and press Scroll to "Trip Log" and... Read More

Maretron's DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Trip Log:", which is used to reset the trip log information back to zero. Read More

You display the DST100 trip log information on a DSM150, DSM200, or DSM250 in the following way. Enter menu mode, scroll to "Favorite Screen Setup..." and press Scroll to the favorite screen where you would like to view the trip log and press ... Read More

Transducer offset is either the distance from the waterline to the transducer (DST100 bottom surface), or the distance from the transducer to the bottom of the vessel. Maretron display products (DSM150, DSM200, DSM250, and N2KView) add the transducer... Read More

You clear the Speed Through Water (STW) calibration on individual DSM150s, DSM200s, or DSM250s in the following way. Enter the menu mode, scroll to "Configuration..." and press Scroll to "Device Configuration..." and press Scroll to the DST100 and... Read More

Maretron's DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Speed Calibration...", which is used to set a multiplier for adjusting the Speed Through Water (STW) coming from the DST100. Read More

Maretron's DSM200 and DSM250 displays have a DST100 configuration setting called "Clear Speed Calibration:", which is used wipe out or clear the multiplier used by the displays to adjust the Speed Through Water (STW) value coming from a DST100. Read More