DSM410

In order to keep the number of Maretron DSM150, DSM200, and DSM250 display menu items to a minimum (there is a possibility of more than 250 batteries, more than 250 engines, more than 250 rudders, etc.), the displays default to only a single rudder.... Read More

Maretron's DSM150, DSM200,and DSM250 displays have a J2K100 configuration setting called "Reset Factory Defaults" which is used to return the J2K100 to its factory settings. Resetting the J2K100 to factory defaults sets the J1939 source address back... Read More

Maretron's DSM150, DSM200,and DSM250 displays have a J2K100 configuration setting called "NMEA 2000 PGN Enable/Disable?" which is used to turn on and off specific messages that are transmitted by the J2K100. Read More

Maretron's DSM150, DSM200,and DSM250 displays have a J2K100 configuration setting called "J1939 Diagnostic Messages:"  which is used to configure the J2K100 to pass diagnostic messages from the J1939 network through to the NMEA 2000 network.... Read More

You display the J2K100 tachometer on a DSM150, DSM200, or DSM250 in the following way. Enter menu mode, scroll to "Favorite Screen Setup..." and press Scroll to the favorite screen where you would like to view the tachometer and press Scroll to ... Read More

You reset the DST100 trip log using a DSM150, DSM200, or DSM250 in the following way. Enter the menu mode, scroll to "Configuration..." and press Scroll to "Device Configuration..." and press Scroll to the DST100 and press Scroll to "Trip Log" and... Read More

Maretron's DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Trip Log:", which is used to reset the trip log information back to zero. Read More

You display the DST100 trip log information on a DSM150, DSM200, or DSM250 in the following way. Enter menu mode, scroll to "Favorite Screen Setup..." and press Scroll to the favorite screen where you would like to view the trip log and press ... Read More

Transducer offset is either the distance from the waterline to the transducer (DST100 bottom surface), or the distance from the transducer to the bottom of the vessel. Maretron display products (DSM150, DSM200, DSM250, and N2KView) add the transducer... Read More

You clear the Speed Through Water (STW) calibration on individual DSM150s, DSM200s, or DSM250s in the following way. Enter the menu mode, scroll to "Configuration..." and press Scroll to "Device Configuration..." and press Scroll to the DST100 and... Read More