DCM100

  DCM100 Firmware Revisions   1.1.1.3 (2023-06-27) Fix the watchdog reset in gen load default Correct response for testmode command "cal get" Added support for PGN 127751 (DC Voltage/Current) Added support for PGN 123993 (Heartbeat) Added... Read More

Yes, many of Maretron device's data can be displayed on Raymarine Chart-plotters With Seatalk and Seatalk ng functionality. Firstly, Maretron recommends that customers verify device compatibility by reviewing the Maretron product's datasheet... Read More

Occasionally, a device can be in "boot mode" (represented in N2KAnalyzer by an orange highlight of the device's entry in the device list). This can happen due to a software update which fails due to network problems. A Maretron device that is ... Read More

Yes, much of Maretron device's data can be shown on Garmin displays with “NMEA 2000” functionality. Firstly, Maretron recommends that customers verify device compatibility by reviewing the Maretron product's datasheet ... Read More

Yes, much of Maretron device's data can be shown on Furuno displays with “CANBUS” functionality. Firstly, Maretron recommends that customers verify device compatibility by reviewing the Maretron product's datasheet specifically,... Read More

Use the N2KAnalyzer software program or a Maretron DSM150, or Maretron DSM250 to perform Maretron Device level configuration. This article will show methods for configuring the DCM100 Using Maretron's N2KAnalyzer software tool.  Pre-requisits:... Read More

The Maretron Capability Matrix helps highlight the system features available for display when designing a system within N2KBuilder.  To generate a system capability Matrix within N2KBuilder simply click on Tools, "Create Maretron Capability... Read More

Maretron Model Device Description NMEA2000 Operating Voltage Engine/Battery Interface CLM100 P/N: M000070  Current Loop Monitor 9 to 32 Volts   SSC200 P/N: M000001, M000021, M000022 NMEA 2000 Solid State Compass HW 1.0 9 to 16 Volts  ... Read More

The SMS100 Status Message is a text message you can receive from the SMS100 containing key pieces of information regarding your vessel. When the SMS100 is installed, you can text the word "Status"  to your SMS100 cellular number ... Read More

The DCM100 is packaged with a Hall Effect sensor (P/N: LEMHTA200-S) which is rated to measure currents up to 200 Amperes. If your application requires measurements exceeding 200 Amperes,  Maretron offers additional sensors: 400 Amperes... Read More