Skip to Content

What are the dimensions of the DCM100 current transducers?

Estimated Reading Time: 1 Minutes
565  Mark Oslund July 30, 2015  DCM100 0

The DCM100 is packaged with a Hall Effect sensor (P/N: LEMHTA200-S) which is rated to measure currents up to 200 Amperes.

If your application requires measurements exceeding 200 Amperes,  Maretron offers additional sensors:

  • 400 Amperes measurement. Use part number LEMHTA400-S when ordering
  • 600 Amperes measurement. Use part number LEMHTA600-S when ordering

All three current sensors for the DCM100 (LEMHTA200-S, LEMHTA400-S, and LEMHTA600-S) have a round opening 32mm or 1.26” in diameter.

Please refer to "hta 100 1000-s e.pdf" located in the attachment section of this article for in depth details regarding the LEM HTA sensor.
Not Rated
What are the dimensions of the DCM100 current transducers?
Estimated Reading Time: 1 Minutes  Mark Oslund July 30, 2015 0
  • Attached Files
  • hta 100 1000-s e.pdf (536 KB) 1130
  •

    COMMENT

    • Powered by PHPKB (Knowledge Base Software)