Skip to Content

Can Maretron’s sensor data be displayed on a Furuno CANBUS network?

Estimated Reading Time: 1 Minutes

Yes, much of Maretron device’s data can be shown on Furuno displays with “CANBUS” functionality. Firstly, Maretron recommends that customers verify device compatibility by reviewing the Maretron product’s datasheet specifically, the transmit PGN section of the datasheet (page 2). Second, review the Chart plotters datasheet for Received PGN list for display to confirm the compatibility.

Please note: Maretron devices allow for multi message distinction for example: PGN 130314(Temperature) allows for source selection with instance number selection, a configuration that can only be adjusted using a Maretron interface. The device configuration can be performed using a Maretron DSM150/250/410 or our N2KAnalyzer software tool only.

 

 

Can Maretron’s sensor data be displayed on a Furuno CANBUS network?
  • COMMENT

  • Powered by PHPKB (Knowledge Base Software)

    Maretron
    Suite 100, 120 Intracoastal Pointe Dr.
    Jupiter, FL 33477

    Get in Touch

    Phone

    (602) 861-1707

    Toll Free

    (866) 550-9100

    Sales

    Support

    Keep in touch

    Copyright © 2023 Maretron. A Littelfuse brand. All rights reserved.