SIM100

What firmware changes have taken place on the Maretron SIM100? Update your device using the N2KAnalyzer software tool.   SIM100 Firmware Versions   1.2.2.2 (2015-08-29) Ensured that PGN 127501 is transmitted immediately when the... Read More

Yes, many of Maretron device's data can be displayed on Raymarine Chart-plotters With Seatalk and Seatalk ng functionality. Firstly, Maretron recommends that customers verify device compatibility by reviewing the Maretron product's datasheet... Read More

Occasionally, a device can be in "boot mode" (represented in N2KAnalyzer by an orange highlight of the device's entry in the device list). This can happen due to a software update which fails due to network problems. A Maretron device that is ... Read More

Yes, much of Maretron device's data can be shown on Furuno displays with “CANBUS” functionality. Firstly, Maretron recommends that customers verify device compatibility by reviewing the Maretron product's datasheet specifically,... Read More

The Maretron Capability Matrix helps highlight the system features available for display when designing a system within N2KBuilder.  To generate a system capability Matrix within N2KBuilder simply click on Tools, "Create Maretron Capability... Read More

Maretron Model Device Description NMEA2000 Operating Voltage Engine/Battery Interface CLM100 P/N: M000070  Current Loop Monitor 9 to 32 Volts   SSC200 P/N: M000001, M000021, M000022 NMEA 2000 Solid State Compass HW 1.0 9 to 16 Volts  ... Read More

Yes, you can use the SIM100 together with a CR Magnetics current sensing relay to indicate that a bulb is burnt out. There are many different available configurations of the current sensing relay, but part numbers that have been tested with the... Read More

The SMS100 Status Message is a text message you can receive from the SMS100 containing key pieces of information regarding your vessel. When the SMS100 is installed, you can text the word "Status"  to your SMS100 cellular number ... Read More

Maretron's Switch Indicator Module monitors dry contacts. Once you have selected the dry contact device, connect the two leads from the device to one of six SIM100 channels. Each channel has two terminals; for example, Channel #0 uses... Read More

      The BHW100 sensor has a etched target molded into the plastic enclosure (located opposite of the side with a Maretron label). The target should be exposed to the area of detection to monitor water ingress in... Read More