Skip to Content

I see that Maretron’s DSM150, DSM200 and DSM250 displays have TLA100 configuration settings called "Gauge Resistance, + to sender:" and "Gauge Resistance, - to sender:"; what are these?

Estimated Reading Time: < 1 Minute
62  Mark Oslund July 12, 2015  DSM150 (Discontinued), DSM200(Discontinued), DSM250 (Discontinued), DSM410, TLA100 0

If the TLA100’s operating mode is set to "NMEA 2000 & Analog Gauge", then it is important to configure the TLA100 with the gauge’s resistances in order for the TLA100 to operate correctly. Please refer to the TLA100 Users Manual for a detailed description of measuring the gauge’s resistance values.
Not Rated
I see that Maretron’s DSM150, DSM200 and DSM250 displays have TLA100 configuration settings called "Gauge Resistance, + to sender:" and "Gauge Resistance, - to sender:"; what are these?
Estimated Reading Time: < 1 Minute  Mark Oslund July 12, 2015 0
Secure Code
Secure Code

  • COMMENT

    • Powered by PHPKB (Knowledge Base Software)