Skip to Content

How do I read a previously saved boat file back into N2KAnalyzer?

Estimated Reading Time: 1 Minutes

 You read a previously saved boat file back into N2KAnalyzer by selecting the "File" menu and clicking on the "Open..." menu item. You can only read a boat file back into N2KAnalyzer if N2KAnalyzer is disconnected from an NMEA 2000 network (connection status is provided in the bottom left hand corner of the N2KAnalyzer window). If N2KAnalyzer is connected to the NMEA 2000 network, then you need to disconnect from the network by selecting the "File" menu and clicking on the "Disconnect from NMEA 2000 Network" menu item. Once N2KAnalyzer is disconnected from the NMEA 2000 network the "Open..." menu item found underneath the "File" menu can be used to read in an existing boat file.

Clicking on the "Open..." menu item causes a file browser to open where you can locate a chose a file to be read into N2KAnalyzer.

How do I read a previously saved boat file back into N2KAnalyzer?
  • COMMENT

  • Powered by PHPKB (Knowledge Base Software)

    Maretron
    Suite 100, 120 Intracoastal Pointe Dr.
    Jupiter, FL 33477

    Get in Touch

    Phone

    (602) 861-1707

    Toll Free

    (866) 550-9100

    Sales

    Support

    Keep in touch

    Copyright © 2023 Maretron. A Littelfuse brand. All rights reserved.