Skip to Content

Can I turn On and Off loads connected to the DCR100 using the DSM150 or DSM250?

Estimated Reading Time: 1 Minutes

Yes, you can turn On and Off loads connected to the DCR100 using the DSM150 or DSM250. To do so, you should understand a few things about the DSM150 or DSM250 and its favorite screens. First, you need to understand how to setup a favorite screen within the DSM150 or DSM250 and second, you need to understand how to place the DSM150 or DSM250 into "Control" mode for actually turning circuits On and Off. Please watch the first video to learn how to setup up a favorite screen that contains switch components for turning On and Off circuits. Please watch the second video to learn how to control the switch components contained on a favorite screen.

 

 

 

 

 

 

Can I turn On and Off loads connected to the DCR100 using the DSM150 or DSM250?
  • Attached Files
  • DSM_DCR_Control#1.1.m4v (6.04 MB) 875
  • DSM_DCR_Config#1.m4v (6.4 MB) 827
  • COMMENT

  • Powered by PHPKB (Knowledge Base Software)

    Maretron
    Suite 100, 120 Intracoastal Pointe Dr.
    Jupiter, FL 33477

    Get in Touch

    Phone

    (602) 861-1707

    Toll Free

    (866) 550-9100

    Sales

    Support

    Keep in touch

    Copyright © 2023 Maretron. A Littelfuse brand. All rights reserved.