Skip to Content

What firmware changes have taken place on the Maretron DCR100?

Estimated Reading Time: 1 Minutes

What firmware changes have taken place on the Maretron DCR100 Relay Module?

You can update your device using the N2KAnalyzer software tool.

 

DCR100 Firmware Versions


1.1.2.3 (2013-07-19)

  • Removed support for the deprecated 127502 Switch Bank Control parameter group (2458)
  • Added support for hardware timers and counters for each channel (2543)
  • Fix conflict between XALM and XPD command (2547)
  • Updated the supported NMEA 2000 database version to 2.000 (2612)
  • Corrected SN erasing when upgrading from older firmware issue (2651)

 

1.0.3.1 (2011-10-25)

  • Adds ability to lock switches from N2KView or DSM250, preventing them from being turned on or off until unlocked.
  • Adds ability to power up with switches set to a particular state: on, off, or the last state the switch was in before power was lost. This power up state is overridden by the lock setting described above.

 

1.0.1 (2011-04-22)

  • Initial public release

 

 

What firmware changes have taken place on the Maretron DCR100?
  • COMMENT

  • Powered by PHPKB (Knowledge Base Software)