Skip to Content

If the RAA100 is connected and configured to operate in the "NMEA 2000 & Analog Gauge" mode, how do I connect the wires to the back of the analog gauge?

Estimated Reading Time: < 1 Minute
288  Mark Oslund July 17, 2015  RAA100 0

You connect the RAA100 operating in the "NMEA 2000 & Analog Gauge" mode to the gauge in the following way:

  1. connect the black wire to the gauge ground terminal
  2. connect the green wire to the gauge sensor terminal
  3. connect the red wire to the gauge power terminal
Not Rated
If the RAA100 is connected and configured to operate in the "NMEA 2000 & Analog Gauge" mode, how do I connect the wires to the back of the analog gauge?
Estimated Reading Time: < 1 Minute  Mark Oslund July 17, 2015 0
Secure Code
Secure Code

  • COMMENT

    • Powered by PHPKB (Knowledge Base Software)