Skip to Content

Can I set the RAA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?

Estimated Reading Time: < 1 Minute
281  Mark Oslund July 11, 2008  DSM250 (Discontinued), DSM410, RAA100 0

Yes, it is possible to set the RAA100 to accept American standard resistive sensors using Maretron’s DSM150, DSM200, or DSM250 display. Set the mode using Maretron’s DSM150, DSM200, or DSM250 display in the following way. Enter menu mode, scroll to "Configuration…" and press enter. Scroll to "Device Configuration…" and press enter. Scroll to the row containing the RAA100 and press enter. Scroll to "Rudder Angel Calibration:" and press enter. Scroll until you find "American Standard (240-33ohms)" and press enter.

Not Rated
Can I set the RAA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Estimated Reading Time: < 1 Minute  Mark Oslund July 11, 2008 0
Secure Code
Secure Code

  • COMMENT

    • Powered by PHPKB (Knowledge Base Software)