If the RAA100 is connected and configured to operate in the "NMEA 2000 & Analog Gauge" mode, how do I connect the wires to the back of the analog gauge?

You connect the RAA100 operating in the "NMEA 2000 & Analog Gauge" mode to the gauge in the following way:

1. connect the black wire to the gauge ground terminal
2. connect the green wire to the gauge sensor terminal
3. connect the red wire to the gauge power terminal

Article ID: 288
Created: July 11, 2008
Last Updated: July 17, 2015
Author: Mark Oslund [[email protected]]

Online URL: https://www.maretron.com/wp-content/phpkbv95/article.php?id=288