Articles Search Results

The RAA100 draws less than 100mA (LEN=2) of current from the NMEA 2000 network at 12 volts, or 1.2 watts of power. Read More

The RAA100 draws less than 100mA (LEN=2) of current from the NMEA 2000 network. Read More

Yes, you can use the RAA100 if the hard over points are not 60 degrees because the RAA100 can be custom calibrated for virtually any stop angle position. Hard over points can be calibrated over resistance values of 0 to 300 ohms. Read More

You connect the RAA100 operating in the "NMEA 2000 & Analog Gauge" mode to the gauge in the following way: connect the black wire to the gauge ground terminal connect the green wire to the gauge sensor terminal connect the red wire to the gauge... Read More

You connect the RAA100 operating in the NMEA 2000 mode (i.e., without analog gauge) to a resistive sensor in the following way: connect the black wire to the sensor ground terminal connect the white wire to the sensor positive terminal Read More

The RAA100 is compatible with resistive rudder style sending unit. The brand, VDO manufacturers a sensor (Figure#1) that can output 10-180Ω of resistance range. Simply connect the RAA100's white and black wires to the VDO sender's positive... Read More

The RAA100 works with resistive rudder angle senders (i.e., the resistance changes with rudder angle). In the U.S., the standard for resistive senders is 240 to 30 ohms where 240 ohms represents 60 degrees to port and 30 ohms represents 60 degrees to... Read More

You reset the RAA100 to transmit the factory default messages using Maretron's DSM250 display in the following way. Enter menu mode, scroll to "Configuration…" and press enter. Scroll to "Device Configuration…" and press enter. Scroll... Read More

Yes, it is possible to turn on and off the RAA100 transmitted messages (or PGNs) using Mareton's DSM150, DSM200, or DSM250 display. On the display, enter menu mode, scroll to "Configuration…" and press enter. Scroll to "Device Configuration... Read More

Yes, it is possible to calibrate the RAA100 to accept non-standard resistive sensors or to set custom hard over angles using Maretron's DSM150, DSM200, or DSM250 display. Set the mode using Maretron's DSM150, DSM200, or DSM250 display in the... Read More