Skip to Content

If the RAA100 is connected and configured to operate in the "NMEA 2000" mode (i.e., without an analog gauge), how do I connect the wires to the resistive sensor?

Estimated Reading Time: < 1 Minute
287  Mark Oslund July 17, 2015  RAA100 0

You connect the RAA100 operating in the NMEA 2000 mode (i.e., without analog gauge) to a resistive sensor in the following way:

  1. connect the black wire to the sensor ground terminal
  2. connect the white wire to the sensor positive terminal
Not Rated
If the RAA100 is connected and configured to operate in the "NMEA 2000" mode (i.e., without an analog gauge), how do I connect the wires to the resistive sensor?
Estimated Reading Time: < 1 Minute  Mark Oslund July 17, 2015 0
Secure Code
Secure Code

  • COMMENT

    • Powered by PHPKB (Knowledge Base Software)