Skip to Content

If the TLA100 is connected and configured to operate in the "NMEA 2000" mode (i.e., without an analog gauge), how do I connect the wires to the resistive sensor?

Estimated Reading Time: < 1 Minute
76  Mark Oslund July 12, 2015  TLA100 0

You connect the TLA100 operating in the NMEA 2000 mode (i.e., without analog gauge) to a resistive sensor in the following way:

  1. connect the black wire to the sensor ground terminal
  2. connect the white wire to the sensor positive terminal.
Not Rated
If the TLA100 is connected and configured to operate in the "NMEA 2000" mode (i.e., without an analog gauge), how do I connect the wires to the resistive sensor?
Estimated Reading Time: < 1 Minute  Mark Oslund July 12, 2015 0
Secure Code
Secure Code

  • COMMENT

    • Powered by PHPKB (Knowledge Base Software)