Skip to Content

I have a STEYR Engine connected to a STEYR Control Center SCC, What cable should be used to connect the J2K100?

Estimated Reading Time: < 1 Minute

The STEYR SCC system is J1939 compatible to a J2K100. Use the MCF-2M-D4 cable as a connection to a single or dual J2K100 segment for engine system conversion.  The MCF-2M-D4 can be connected to an unused panel mating connection originating from the SCC display’s  one of two 4 pin pigtails. Details can be located at http://www.steyr-motors.com, under SCC 4/6 cylinder applications.

I have a STEYR Engine connected to a STEYR Control Center SCC, What cable should be used to connect the J2K100?
  • Attached Files
  • nmea2000_converter.pdf (835.8 KB) 1385
  • COMMENT

  • Powered by PHPKB (Knowledge Base Software)