What firmware changes have taken place on the Maretron RAA100?

2.0.2.3 2016-08-29):

• Corrected a problem where the device could lose its instance information after a power cycle (3968)

2.0.1.5  (2015-10)

- Initial Release to support Hardware Version 2

1.4.10 (2009-08-12)

- Corrected a problem with Maretron Label support where the device would not always accept a new label

1.4.9 (2009-02-03)

- Added support for labeling so that the device can easily be identified with a user-programmable string.

1.4.8 (2008-03-18)

- Fixed error in CAN filter implementation resulting in non-responsiveness

- Fixed a problem that prevented configuration from working when the configuring device had a node address greater than 127 (0x7F)

1.4.7 (2008-03-10)

- Made improvements to device responsiveness to NMEA 2000 messages

1.4.6 (2008-02-29)

- Made improvements to device responsiveness to NMEA 2000 messages

1.4.5 (2008-01-21)

- Made improvements to device responsiveness to NMEA 2000 messages

1.4.4 (2007-09-28)

- No user-visible changes

1.4.3 (2007-09-28)

- Corrected issue in CAN driver that caused RAA100 not to respond to product selection sometimes.

1.4.2 (2007-03-29)

- Corrected problems with custom calibration

1.4.1 (2006-05-24)

- Fixed an issue with NMEA 2000 certification

1.4 (2006-05-17)

- Fixed a problem causing occasional loss of received messages

1.2 (2006-03-21)

- Initial public release