Knowledge Base
Home » Categories » Multiple Categories

What type of tank senders does the TLA100 work with?

The TLA100 works with resistive tank senders (i.e., the resistance changes with tank level). In the U.S., the standard for resistive senders is 240 to 30 ohms where 240 ohms represents empty and 30 ohms represents full. The European standard for resistive senders is 10 to 180 ohms where 10 ohms represents empty and 180 ohms represents full. The TLA100 can be configured to accept either American or European sensors.

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Clear Speed Calibration:"; what is this?
Viewed 2349 times since Sun, Jun 22, 2008
I see that the FPM100 has an accessory for measuring pressures in the range of -1Bar to 1 Bar. Can I use this sensor to monitor my fuel filters?
Viewed 2026 times since Thu, Dec 18, 2014
Can I set the TLA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 1965 times since Fri, Jun 20, 2008
Can I set the RAA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2382 times since Fri, Jul 11, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Transducer Depth Offset:"; what is this?
Viewed 2843 times since Mon, Jun 25, 2012
How do I display the J2K100 generator average AC current on Maretron’s DSM150 or DSM250 display?
Viewed 2321 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Capacity:"; what is this?
Viewed 2165 times since Thu, Jun 19, 2008
How do I reset the J2K100 to send the factory default NMEA 2000 messages (or PGNs)?
Viewed 2408 times since Thu, Jan 14, 2010
Why doesn’t my tank display doesn’t read empty when the tank is empty?
Viewed 1846 times since Sun, Jun 22, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Operating Mode:"; what is this?
Viewed 2074 times since Thu, Jun 19, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.