Maretron announces the release of version 6.4.1 of the N2KView® V3 software. The Computer (PC & MAC) version of N2KView is available via the following link https://www.maretron.com/products/n2kview-vessel-monitoring-and-control-software/#lqd-tab... Read More

The prerequisite for using this guide requires the use of a Windows PC and Maretron's N2KAnalyzer program installed. The hardware required for Maretron device configuration is the USB100 or IPG100 Gateway connected to a... Read More

Before we discuss how to monitor the bilge with Maretron equipment, let's take a look at a typical bilge pump and alarm wiring diagram (see Figure 1). Notice that there are two ways to turn the bilge pump on. First, there is the float switch -- when... Read More

Yes, you can use the DCR100 to monitor DC current flow to loads using one of Maretron's display products (e.g., N2KView, DSM150, or DSM250). Each of the six channels within the DCR100 reports how much current is flowing to the load, which is useful... Read More

No. Maretron's EGT sensor is meant to measure the temperature of the exhaust gas temperature, not the temperature of the exhaust gas after it has been cooled by water. Placing the EGT probe downstream of the riser or elbow will render the device... Read More

Yes, you can use the SIM100 to monitor Carbon Monoxide (CO) detectors as long as the detector has an auxiliary contact. Maretron offers a CO detector ( https://www.maretron.com/support/manuals/CO-CO1224T%20Installation%20Instructions%201.1.html ) The... Read More