Yes, N2Kanalyzer offers two types of tank calibrations: Manual Table and Step Fill. Both configuration features can be used to calibrate the correct tank volume for your Maretron tank monitoring product. Used in in... Read More

N2KAnalyzer is a PC based application, when paired with a Maretron gateway, allows a user to gain access to the devices on their NMEA 2000® network for providing Maretron device setup, network analysis, network troubleshooting and Maretron device... Read More

For users setting up or reviewing N2KView configurations while off the vessel, they will identify that some viewing content may not be available to access such as Alerts and Cameras.   In order to acquire access to such features, we will take... Read More

Does Maretron offer quick setup instructions for a dual J2K100 setup? Refer to this article for help on setting up your J2K100s especially when connected to the following engine manufacturers J1939 networks: Caterpillar, John Deere, Cummins... Read More

Does Maretron offer a DSM410 Gimbal mount? No, Maretron does not sell a DSM410 gimble mount. However, we do provide a 3D printer "STL" file (located in the attachment section below) that allows a 3D printer program to make the hardware on a 3D... Read More

Maretron's Switch Indicator Module monitors dry contacts. Once you have selected the dry contact device, connect the two leads from the device to one of six SIM100 channels. Each channel has two terminals; for example, Channel #0 uses... Read More

An Indicator Status component uses the NMEA 2000 message called "Binary Switch Bank Status" to show three condition states: On Off Error A RIM100, SIM100, and DCR100 all transmit the necessary message for the N2KView component to work. You can create... Read More

The prerequisite for using this guide requires the use of a Windows PC and Maretron's N2KAnalyzer program installed. The hardware required for Maretron device configuration is the USB100 or IPG100 Gateway connected to a... Read More

Maretron offers several accessories that allow you to make a custom NMEA 2000 cable.It may be necessary to make a custom cable for the following reasons: Cable runs longer than 10m in length Routing raw cables micro/mid through bulkheads, wire trays,... Read More

The DCR100 has a DC current calibration option. If you have connected a DC load to a channel of the DCR100 and have not performed the "Current Sensor Zero Offset Calibration", this may affect the command of this channel especially if the DCR100... Read More