Skip to Content

Can I use the DCR100 to switch AC loads?

Estimated Reading Time: < 1 Minute
526  Mike Coleman June 6, 2014  DCR100 0

You can not use the DCR100 to directly switch AC loads, but you can use the DCR100 with an external relay to turn On and Off AC loads.

- A Solid State Relay (SSR) can be used to switch an AC load as shown in the illustration below.
Rating: 5 (1 Votes)
Can I use the DCR100 to switch AC loads?
Estimated Reading Time: < 1 Minute  Mike Coleman June 6, 2014 0
Secure Code
Secure Code

  • COMMENT

    • Get notified when new articles are added to the knowledge base.

    Powered by PHPKB (Knowledge Base Software)