Maretron Knowledge Base - Related Articles https://www.maretron.com/wp-content/phpkbv95/article.php?id=117 This RSS Feed contains Related Articles of the knowledge base. You can click on the title to view its content. Powered by PHPKB (https://www.phpkb.com)
https://www.maretron.com/wp-content/phpkbv95/article.php?id=103 What are the allowable mounting positions for the SSC200? https://www.maretron.com/wp-content/phpkbv95/article.php?id=103 https://www.maretron.com/wp-content/phpkbv95/article.php?id=127 I see that Maretron`s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Reset Factory Defaults"; what is this? https://www.maretron.com/wp-content/phpkbv95/article.php?id=127 https://www.maretron.com/wp-content/phpkbv95/article.php?id=423 What firmware changes have taken place on the Maretron SSC200? https://www.maretron.com/wp-content/phpkbv95/article.php?id=423 https://www.maretron.com/wp-content/phpkbv95/article.php?id=108 Why does the SSC200 rate of turn indicate that I am turning when I am not turning? https://www.maretron.com/wp-content/phpkbv95/article.php?id=108 https://www.maretron.com/wp-content/phpkbv95/article.php?id=119 How do I reset the SSC200 to send the factory default NMEA 0183 sentences? https://www.maretron.com/wp-content/phpkbv95/article.php?id=119 https://www.maretron.com/wp-content/phpkbv95/article.php?id=114 How do I display the SSC200 pitch on Maretron`s DSM150, DSM200, or DSM250? https://www.maretron.com/wp-content/phpkbv95/article.php?id=114 https://www.maretron.com/wp-content/phpkbv95/article.php?id=297 How do I calibrate the SSC200 pitch to read zero using Maretron`s DSM150, DSM200, or DSM250 display? https://www.maretron.com/wp-content/phpkbv95/article.php?id=297 https://www.maretron.com/wp-content/phpkbv95/article.php?id=111 How do I display the SSC200 roll angle on Maretron`s DSM150, DSM200, or DSM250 display? https://www.maretron.com/wp-content/phpkbv95/article.php?id=111 https://www.maretron.com/wp-content/phpkbv95/article.php?id=101 I see that Maretron`s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Installation Offset Calibration?"; what is this? https://www.maretron.com/wp-content/phpkbv95/article.php?id=101 https://www.maretron.com/wp-content/phpkbv95/article.php?id=124 I see the SSC200 uses the NMEA 0183 identifier II (i.e., the two letters following the $ of an NMEA 0183 sentence); is it possible to change the identifier to some other value? https://www.maretron.com/wp-content/phpkbv95/article.php?id=124