What firmware changes have taken place on the Maretron CLM100 Current Loop Monitor?

You can update your device using the N2KAnalyzer tool.

1.2.2.4 (2021-08-11)

1.2.1.1 (2020-08-14)

Support Engine PGNs (CLM100 device will act as one engine node) (4027, 4594, 4603, 4619, 4645)
Support Transmission PGNs (CLM100 device will act as one transmission node)
Support Battery PGNs (CLM100 device will act as one battery node)
Support Vessel PGN: 130576, Trim Tab Status (4027)
Support DF108 (Power Extended Range (W), int32) (4619)
Support DF68 (Power, Low (mW), uint16) (4619)
Support "Percent Engine Torque" (4619)
Re-transmit label PGN when channel configuration change (CLM100 will monitor the change(s) every 1s to reduce the repeated label PGNs transmitted) (4181)
Enable 4-20 mA support in 130840

1.1.1.1 (2016-08-29):

Corrected a problem where PGN 130840 sometimes appeared in the Transmitted PGN List even though it is not being transmitted (3727)
Manufacturing improvements (3973)

1.0.5.1 (2016-06-27)

1.0.2.1 (2015-10-07)

Article ID: 625
Created: October 8, 2015
Last Updated: March 18, 2022
Author: Ron De Pastino [ron.depastino@maretron.com]

Online URL: https://www.maretron.com/wp-content/phpkbv95/article.php?id=625