Occasionally, a device can be in "boot mode" (represented in N2KAnalyzer by an orange highlight of the device's entry in the device list). This can happen due to a software update which fails due to network problems. A Maretron device that is ... Read More
N2KAnalyzer
DCR100 channels have two possible operating modes: “Normal”, in which the DCR100 channel responds to standard NMEA 2000 switching commands, and “Annunciator”, in which the channel may be connected to a power source for a... Read More
en discussing the TLM100, TLM150, and TLM200 ultrasonic tank level sensors, the term "deadband" is a term used when describing an operating range where a signal start and signal end cannot be measured. For an ultrasonic sensor application,... Read More
... Read More
Use the N2KAnalyzer software program or a Maretron DSM150, or Maretron DSM250 to perform Maretron Device level configuration. This article will show methods for configuring the DCM100 Using Maretron's N2KAnalyzer software tool. Pre-requisits:... Read More
You can use the N2KAnalyzer software program or a Maretron DSM150, or Maretron DSM250 to perform the configuration. This article will show methods for configuring the FPM100 Using Maretron's N2KAnalyzer software tool. Pre-requisits: PC with... Read More
Use the N2KAnalyzer software program or a Maretron DSM150, or Maretron DSM250 to perform Maretron Device level configuration. This article will show methods for configuring the TMP100 Using Maretron's N2KAnalyzer software tool. Pre... Read More
Maretron's Switch Indicator Module monitors dry contacts. Once you have selected the dry contact device, connect the two leads from the device to one of six SIM100 channels. Each channel has two terminals; for example, Channel #0 uses... Read More
Yes, the National Marine Electronics Association (NMEA) publishes a list of PGNs, which can be found via this link: http://www.nmea.org/content/nmea_standards/messages_pgns.asp Read More
N2KAnalyzer has a feature that allows for the user to load a saved configuration table onto a TLM100,TLM150, or TLM200 on the NMEA 2000 network. To load a configuration file, use the following process: Start the N2KAnalyzer program. Select a gateway... Read More