The DST110 can be mounted through the hull using either a plastic or bronze housing. The plastic and bronze housing require a 2" hole (51mm) .
Yes, Maretron offers an optional through hull housing in bronze. The Maretron part number for the housing is M33-100. The plastic and bronze housings use the same size hole in the hull (2 inches or 51mm).
You can not use the DCR100 to directly switch AC loads, but you can use the DCR100 with an external relay to turn On and Off AC loads.- A Solid State Relay (SSR) can be used to switch an AC load as shown in the illustration below.
The Maretron Capability Matrix helps highlight the system features available for display when designing a system within N2KBuilder. To generate a system capability Matrix within N2KBuilder simply click on Tools, "Create Maretron Capability... Read More
Yes, you can use the DCR100 in conjunction with Maretron's display products (e.g., N2KView, DSM150, or DSM250) to detect burnt out loads. You can do this in one of two ways; 1) setup a favorite screen to monitor the DC current for a particular load... Read More
Yes, you can use the DCR100 to monitor DC current flow to loads using one of Maretron's display products (e.g., N2KView, DSM150, or DSM250). Each of the six channels within the DCR100 reports how much current is flowing to the load, which is useful... Read More
Two NBE100 network diagram examples are shown in this article. Please note that both diagrams show just one NBE100 allowing the normal NMEA 2000 network restrictions (50 nodes or products, 200m trunk line, 78m of drop length) to be doubled. It is... Read More
Maretron's NBE100 (Network Bus Extender) allows you to extend the maximum node count, network trunk length and cumulative drop length of any NMEA 2000® network. The NBE100 solves bus errors and other electrical issues caused by exceeding any of... Read More
The NBE100 allows you to electrically break up an NMEA 2000 network into individual "network segments". Although the network segments are electrically isolated from each other, the entire network is still one large logical network. What this means is... Read More
Maretron's DCR100 contains 6 Direct Current (DC) relays, each capable of switching up to 10 Amps at 12VDC or 24VDC. The DCR100 connects directly to an NMEA 2000® network, so you can turn on and off the relays from a Maretron DSM150 or DSM250... Read More