Skip to Content

What firmware changes have taken place on the Maretron DSM570?

Estimated Reading Time: 1 Minutes

DSM570 Firmware Versions

What firmware changes have taken place on the Maretron DSM570 display?

Update your device using the N2KAnalyzer software tool.

 

1.8.6.3 (2022-03-16)

  • Fix rolling toad trail issue on VGA resolution display
  • Correct Demo icon position on VGA resolution display
  • Change screen lock mode selection from buttons combination on power up to power down options selections
  • Add testmode command "startup" to support startup options
  • Fix rolling road crash when ellipse cannot be drawn
  • Correct DCM menu display text GEL

 

1.8.5.2 (2021-10-07) - Not Released

  • In power off state, keep internal power supply active if N2K supply voltage is less than 10V

 

1.8.4.6 (2021-04-21)

  • Support Yaw (PGN# 127257)
  • Support Generic Sensor device
  • Support Standard N2K Label (PGN# 130060)
  • Support Shaft Seal Temperature (15) for DD291 (Bug #4702)
  • Fix annunciator stop working after deleting issue (Bug #4652)
  • Add units for Force (Bug #3749)

 

1.8.3.2 (2020-08-14)

  • Support TSM810C, TSM1210C, MBB300C configuration
  • For FFM100 configuration menu, always display K-Factor as 1000 when the K-Factor on FFM100 is 1000. This fix an issue caused after load default to FFM100 and the DSM display the old K-Factor value before loading default, this issue also fixed in the FFM100 SW 1.4.1.1
  • Support CLM100 SW 1.2+
  • Support CLM100 configuration for Battery, Engine, Transmission, and Vessel Devices

 

1.8.1.2 (2018-10-15)

  • Initial customer release
What firmware changes have taken place on the Maretron DSM570?
  • COMMENT

  • Powered by PHPKB (Knowledge Base Software)

    Maretron
    Suite 100, 120 Intracoastal Pointe Dr.
    Jupiter, FL 33477

    Get in Touch

    Phone

    (602) 861-1707

    Toll Free

    (866) 550-9100

    Sales

    Support

    Keep in touch

    Copyright © 2023 Maretron. A Littelfuse brand. All rights reserved.