What firmware changes have taken place on the Maretron WSO100?

What firmware changes have taken place on the Maretron WSO100?


WSO100 Firmware Versions:

2.0.13 (2009-02-11)
-  Reduced the reported LEN (Load Equivalent Number) from 7 to 3 to reflect actual current usage of the device

-  Improved behavior of humidity readings

-  Improved behavior of air temperature readings

2.0.12 (2009-02-12)

- Added support for labeling so that the device can easily be identified with a user-programmable string.

- Enabled transmission of Temperature PGN  130312 by default

- Enabled transmission of Humidity PGN  130313 by default

- Enabled transmission of Pressure PGN  130314 by default

- Added ability to configure rate of transmission of NMEA 2000 messages

 

2.0.11 (2008-03-03)

- Enable transmission of PGN 130310 by default so that displays that support only this environmental PGN (such as Raymarine chartplotters) can display temperature, pressure, and humidity information

- Fixed problem where the device tried to transmit a PGN before it had acquired a node address

 

2.0.10 (2007-11-29)         

- No user-visible changes (manufacturing improvements)

 

2.0.9 (2007-04-10)           

- Added support for new hardware version

 

1.0.8 (2007-01-05)

- No user-visible changes (manufacturing improvements)

 

1.0.7 (2006-10-17)

- Corrected a problem where wind speed could be indicated incorrectly in certain directions

 

1.0.0 (2006-03-24)

- Initial public release