Knowledge Base

Articles: Search Results

  1. How do I set up the EMS100 for my Yanmar engine? In order to setup an EMS100 several things must be known.What senders have been installed on the engine?What type of engine gauge panel is installed with the engine?Where is the factory interface available for the EMS100 engine harness to tee into?On... Read More
  2. What 3-Phase applications is the ACM100 compatible with? The ACM100 is designed to measure 3-Phase "WYE" configurations. However, it can be used to measure many parameters of 3-phase Delta configurations in the following manner:Configure the ACM100 for a circuit type of "3-Phase Y (Ph. A, B, C)"Use the fol... Read More
  3. I see the Tank Level Monitor products have a specification called "deadband"; what is this and how does it affect tank measurements? en discussing the TLM100, TLM150, and TLM200 ultrasonic tank level sensors, the term "deadband" is a term used when describing an operating range where a signal start and signal end cannot be measured.For an ultrasonic sensor application, deadband is... Read More
  4. Why won’t the GPS100 lock on and produce a position fix? The GPS100 may not lock on and provide a fix for several reasons. First, the GPS100 needs a clear view of the entire sky, so you need to make sure the GPS100 is not obstructed by a deck house, TV antenna, or any other object that blocks the GPS100 fr... Read More
  5. With regard to the GPS100, what is a cold start? When the GPS100 is started or powered up, it attempts to get a position fix in one of three modes,hot start (typically acquires a fix in 8 seconds),warm start (typically acquires a fix in 38 seconds), orcold start (typically acquires a fix in 45 seco... Read More
  6. With regards to the GPS100, what is a warm start? When the GPS100 is started or powered up, it attempts to get a position fix in one of three modes,hot start (typically acquires a fix in 8 seconds),warm start (typically acquires a fix in 38 seconds), orcold start (typically acquires a fix in 45 seco... Read More
  7. With regards to the GPS100, what is a hot start? When the GPS100 is started or powered up, it attempts to get a position fix in one of three modes,hot start (typically acquires a fix in 8 seconds),warm start (typically acquires a fix in 38 seconds), orcold start (typically acquires a fix in 45 seco... Read More
  8. What accessories can I order for the TLM100 and which one should I use? The following accessories are available for the TLM100.TA-5H-1.25BSP   1.25" BSP Displacement Hull Tank Adapter TA-5H-1.5NPT    1.5" NPT Displacement Hull Tank AdapterA focus tube(TFT) can help technicians control the ultrasonic signal path generated... Read More
  9. I have installed the TLM100 and see incorrect tank levels; what does this mean?  The TLM100 uses an ultrasonic signal to determine a distance measurement from sensor to level.The tank application must be compatible with the TLMXXX measurement technology. If you have already installed a TLMXXX and received unexpected results, the... Read More
  10. What firmware changes have taken place on the Maretron RIM100? What firmware changes have taken place on the Maretron RIM100?RIM100  Firmware Versions 1.2.1.1 (2015-10)- Manufacturing Improvements1.1.4.3(2013-07-19)- Added support for hardware timers and counters for each channel. These timers and counters are c... Read More
Displaying 11 to 20 out of 23 records First Page Previous Page Page of 3 Next Page Last Page
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.