Knowledge Base

Articles: Search Results

  1. How do I connect the Dometic Q-logic controller to the J2K100 for N2KView control? First, you will need to purchase or connect the Q-logic J1939 board or confirm you have one already working on board your vessel. Figure 1 illustrates what the Q-logic J1939 interface should look like.Once you can confirm the J1939 interface is conne... Read More
  2. What is the difference between an anemometer that uses mechanical cups and vane versus an anemometer that uses ultrasonic technology? For a discussion on the differences between mechanical and ultrasonic anemometers, please see the article entitled "Anemometer Technology.pdf" under Attachments found below.... Read More
  3. If the RAA100 is connected and configured to operate in the "NMEA 2000 & Analog Gauge" mode, how do I connect the wires to the back of the analog gauge? You connect the RAA100 operating in the "NMEA 2000 & Analog Gauge" mode to the gauge in the following way:connect the black wire to the gauge ground terminalconnect the green wire to the gauge sensor terminalconnect the red wire to the gauge powe... Read More
  4. If the RAA100 is connected and configured to operate in the "NMEA 2000" mode (i.e., without an analog gauge), how do I connect the wires to the resistive sensor? You connect the RAA100 operating in the NMEA 2000 mode (i.e., without analog gauge) to a resistive sensor in the following way:connect the black wire to the sensor ground terminalconnect the white wire to the sensor positive terminal... Read More
  5. How do I reset the DST100 total distance log? The DST100 total distance log is not resettable. The total distance log indicates the total distance traveled since the DST100 was purchased and installed in the vessel.... Read More
  6. With regards to the DST100, what is the difference between the trip log and the total log? Trip log is the distance traveled since the last reset and can be used to record how far you go on a particular trip. Total log is the total distance the vessel has traveled since the DST100 was purchased and installed on the vessel. You can reset th... Read More
  7. How do I reset the DST100 trip log using Maretron’s DSM150, DSM200, or DSM250 display? You reset the DST100 trip log using a DSM150, DSM200, or DSM250 in the following way.Enter the menu mode, scroll to "Configuration..." and press < Enter >Scroll to "Device Configuration..." and press < Enter >Scroll to the DST100 and press < Enter >S... Read More
  8. I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Trip log:"; what is this? Maretron's DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Trip Log:", which is used to reset the trip log information back to zero.... Read More
  9. How do I display the DST100 trip log using Maretron’s DSM150, DSM200, or DSM250 display? You display the DST100 trip log information on a DSM150, DSM200, or DSM250 in the following way.Enter menu mode, scroll to "Favorite Screen Setup..." and press < Enter >Scroll to the favorite screen where you would like to view the trip log and press... Read More
  10. Why is the SSC200 compass better than other marine compasses that use fluxgate technology? The SSC200 compass is better than other marine compasses that use fluxgate technology because there are no moving parts in the SSC200. Compasses using fluxgate technology have a coil floating in a liquid, and once this coil is set in motion (vessel i... Read More
Displaying 1 to 10 out of 65 records First Page Previous Page Page of 7 Next Page Last Page
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.