Knowledge Base

Articles: Search Results

  1. Can I custom calibrate the RAA100 for non-standard resistance sensors or can I do custom calibration for hard over points other than 60 degrees? Yes, it is possible to calibrate the RAA100 to accept non-standard resistive sensors or to set custom hard over angles using Maretron's DSM150, DSM200, or DSM250 display. Set the mode using Maretron's DSM150, DSM200, or DSM250 display in the followin... Read More
  2. Why doesn’t my rudder display read hard over when the rudder is hard over? The rudder display may not read hard over even though the rudder is hard over if the resistive sensor is not turning throughout its entire range. You can fix this by either adjusting the resistive sensor to turn across its entire range or you can per... Read More
  3. Can I use the RAA100 if my hard over points are not 60 degrees? Yes, you can use the RAA100 if the hard over points are not 60 degrees because the RAA100 can be custom calibrated for virtually any stop angle position. Hard over points can be calibrated over resistance values of 0 to 300 ohms.... Read More
  4. How is J1939 different from NMEA 2000? J1939 and NMEA 2000 networks are both based on the same hardware (Controller Area Network (CAN)), and both protocols use the same message format (the messages are actually compatible and can coexist on the same network), however, NMEA uses different ... Read More
  5. Can I shrink wrap the end of the pressure transducer cable? Maretron's guage type pressure transducers (0-1.5 PSI, 0-3 PSI, 0-5 PSI, 0-10 PSI, 0-50 PSI) require external venting relative to the atmospheric to operate. For our gauge sensors, the venting takes place through the end of the cable assembly. For a ... Read More
  6. How do I update my N2KServer license key to support multiple N2KView features? As shipped from the factory, N2KView supports one connected client (which can be N2KView running on a PC or mobile phone, a MBB100 Black Box for Vessel Monitoring and Control, TSM800/1330C (Touch Screen Display) or  DSM800 Vessel Monitoring and Contr... Read More
  7. I receive an error message (this is a general error message with no ID) when I attempt to update my N2View Software; what should I do?  The error message received is due to  your N2KView  certificate expiring. This is a common issue if you miss an update. First, you want to back up all your *.* .N2K or *.*.nvs file so another location on your PC. Uninstall the N2KView program from t... Read More
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.