Knowledge Base

Articles: Search Results

  1. How do I configure a DCR100 channel to work as an annunciator for an N2KView Alert? The DCR100 offers two types of channel configuration:relayannunciatorThe annunciator configuration allows for N2KView to command a DCR100 channel to close a relay when an alert is configured to have an action,as shown in Figure 1 below.Figure 1.This ... Read More
  2. I know that the RAA100 uses resistive rudder angle sensors; who manufactures resistive sensors? The RAA100 is compatible with resistive rudder style sending unit. The brand, VDO manufacturers a sensor (Figure#1) that can output 10-180Ω of resistance range. Simply connect the RAA100's white and black wires to the VDO sender's positive(... Read More
  3. I would like to see NMEA2000 Engine and Transmission warnings on my N2K network, what J1939 diagnostic codes will the J2K100 convert? The J2K100 will convert J1939 Diagnostic SPN/PGNs to NMEA2000 Engine and Transmission Warning messages. Consult the engine manufacturer to determine if an engine will transmit these messages over the NMEA2000 bus.The following table (figure 1) provid... Read More
  4. How do I monitor the bilge with Maretron equipment? Before we discuss how to monitor the bilge with Maretron equipment, let's take a look at a typical bilge pump and alarm wiring diagram (see Figure 1). Notice that there are two ways to turn the bilge pump on. First, there is the float switch -- ... Read More
  5. How do I show simple bilge information on Mareton’s DSM150 or DSM250 displays? Knowldege base article 578 showed how to do simple bilge monitoring using Maretron's Run Indicator Module (RIM100). This article shows how the monitored information from article 578 can be displayed on Maretron's DSM150 and DSM250 displays.... Read More
  6. What is the supplied cable length of the TMP100 sensors; is it possible to extend the cable? Maretron thermistor probes come with 6' long wires. Yes, you can extend Maretron TMP100 sensor wires to complete temperature sensing applications throughout a vessel.In many applications technicians have extended thermistor wires up to 100 feet ... Read More
  7. How do I set up My Maretron Telemetric Cloud Service? Maretron Telemetric Cloud Service (TCS) offers an extremely powerful way to send periodic data from the Maretron vessel monitoring and control system onboard your vessel to a cloud based storage service. Simply connect your Maretron Black Box (MBB200... Read More
  8. How do I extract Maretron Telemetric Cloud Service data using N2KExtractor? Extracting Telemetric Cloud Service (TCS) data from your vessel for review with N2KExtractor requires an Internet connection.First, start N2KExtractor on your PC. Go to File->Connect to Telemetric Cloud Service (see Figure 1). You will be prompted to... Read More
  9. What configuration options are available for the TMP100? Use the N2KAnalyzer software program or a Maretron DSM150, or Maretron DSM250 to perform Maretron Device level configuration. This article will show methods for configuring the TMP100 Using Maretron's N2KAnalyzer software tool.  Pre-requisits:PC... Read More
  10. What configuration options are available for the FPM100? You can use the N2KAnalyzer software program or a Maretron DSM150, or Maretron DSM250 to perform the configuration. This article will show methods for configuring the FPM100 Using Maretron's N2KAnalyzer software tool. Pre-requisits:PC with N2KAn... Read More
Displaying 1 to 10 out of 44 records First Page Previous Page Page of 5 Next Page Last Page
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.