What firmware changes have taken place on the Maretron EMS100?



What firmware changes have taken place with the EMS100?

EMS100 Firmware Versions



1.4.1 (2009-08-21)

-       Corrected a problem where fuel rate had been incorrectly transmitted as zero. It is now transmitted as “Data Not Available”

 

1.4 (2009-08-19)

-       Added ability to configure transmission periods for periodic PGN’s

-       Added ability to configure flywheel teeth to a resolution of 0.1 to support alternator tachometer signals

-       Added support for labeling so that the device can easily be identified with a user-programmable string.

-       Added YANMAR W/THRESHOLD and YANMAR/VDO W/THRESHOLD types to oil pressure and boost pressure senders.  These types will read 0 pressure whenever the raw pressure reading is below 10% of full scale.  This is to prevent non-zero readings with the engine powered but not running and slightly inaccurate senders

 

1.3 (2008-03-27)

-      Added support for YANMAR/VDO Water temperature sender

-      Corrected YANMAR/VDO oil pressure sender maximum from 5 bar to 10 bar

 

1.1.4 (2007-11-28)

-       Corrected issue with engine hours incrementing slightly faster than appropriate

-       Adjusted sender resistance tables to be more accurate

 

1.1 (2007-11-15)

-       Initial public release



Article Number: 418
Posted: Thu, Jan 19, 2012 5:00 PM
Last Updated: Tue, May 27, 2014 9:49 PM

Online URL: https://www.maretron.com/support/knowledgebase/phpkbv7/article.php?id=418