Knowledge Base
Home » Categories » Multiple Categories

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Magnetic Deviation Calibration?"; what is this?

Maretron's DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Magnetic Deviation Calibration...", which is used to calibrate the compass to account for sources of magnetic deviation on the vessel.

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
I navigate using magnetic heading and not true heading; how do I use the SSC200 compass and Maretron’s DSM150, DSM200, or DSM250 display to view my heading in magnetic?
Viewed 2707 times since Thu, Jun 19, 2008
How do I display the GPS100 latitude and longitude or position using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2135 times since Sun, Jun 22, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Type:"; what is this?
Viewed 2489 times since Sun, Jun 22, 2008
How do I reset the TLA100 to send the factory default messages (or PGNs)?
Viewed 1832 times since Fri, Jun 20, 2008
How do I clear the WSO100 installation offset using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2768 times since Sat, Aug 2, 2008
What is the default calibration setting for the TLA100?
Viewed 2456 times since Fri, Jun 20, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Number:"; what is this?
Viewed 2380 times since Thu, Jun 19, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Clear Speed Calibration:"; what is this?
Viewed 2330 times since Sun, Jun 22, 2008
How do I configure a channel on the TMP100 using Maretron’s DSM250?
Viewed 2423 times since Fri, Jun 11, 2010
How do I display the J2K100 engine percent load on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2515 times since Thu, Jan 14, 2010
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.