Knowledge Base
Home » Categories » Multiple Categories

How do I display the SSC200 magnetic heading on Maretron’s DSM150, DSM200, or DSM250 display?

You display the SSC200 magnetic heading information on a DSM150, DSM200, or DSM250 in the following way:

  1. Enter menu mode, scroll to "Favorite Screen Setup..." and press < Enter >
  2. Scroll to the favorite screen where you would like to view the magnetic heading and press < Enter >
  3. Scroll to "Data:" and press < Enter >
  4. Scroll to "Heading" and press < Enter >
  5. Scroll to "Magnetic" and press < Enter >
  6. Press the < Back > key three times to exit menu mode and return to the normal viewing mode
  7. Scroll through your screens to the favorite screen you selected for magnetic heading
Attachments (2) Attachments
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "J1939 Diagnostic Messages:"; what is this?
Viewed 2718 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 2024 times since Fri, Jun 20, 2008
How do I display the J2K100 engine boost pressure on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3071 times since Thu, Jan 14, 2010
How do I set the TLA100 configuration setting called "Gauge Resistance, - to sender" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2513 times since Fri, Jun 20, 2008
How do I display the GPS Course Over Ground (COG) using Maretron’s DSM150 or DSM250 display?
Viewed 3404 times since Tue, Jun 17, 2008
How do I configure a channel on the SIM100 using Maretron’s DSM250 Display?
Viewed 1861 times since Tue, Sep 1, 2009
Using N2KAnalyzer, how do I recover a Maretron device?
Viewed 2696 times since Thu, Dec 22, 2011
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Clear Speed Calibration:"; what is this?
Viewed 2507 times since Sun, Jun 22, 2008
Why does the SSC200 roll angle not read zero when the vessel is flat in the water?
Viewed 2121 times since Thu, Jun 19, 2008
I see the SSC200 uses the NMEA 0183 identifier II (i.e., the two letters following the $ of an NMEA 0183 sentence); is it possible to change the identifier to some other value?
Viewed 2037 times since Tue, Jun 17, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.