Knowledge Base
Home » Categories » Tank Monitoring » TLA100

What are the approximate dimensions of the TLA100?

The TLA100 is approximately 4"  (10.2 cm) long, 1.25" (3.2 mm) wide, and 1" (2.5 cm) tall.

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
If the TLA100 is connected and configured to operate in the "NMEA 2000 & Analog Gauge" mode, how do I connect the wires to the back of the analog gauge?
Viewed 2617 times since Sun, Jun 22, 2008
How do I set the TLA100 operating mode using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2947 times since Fri, Jun 20, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Reset Factory Defaults"; what is this?
Viewed 2730 times since Fri, Jun 20, 2008
What type of information can be viewed on Maretron’s display products, and what products are required to generate the data to be displayed?
Viewed 24778 times since Tue, Oct 25, 2011
Can Maretron devices be displayed on a Raymarine Seatalk NG network?
Viewed 6985 times since Wed, Feb 25, 2015
How do I set the TLA100 tank number or instance using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3236 times since Fri, Jun 20, 2008
What are the voltage specifications for each Maretron device?
Viewed 7665 times since Thu, Dec 22, 2011
How do I set the TLA100 tank type using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3149 times since Fri, Jun 20, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 2593 times since Fri, Jun 20, 2008
How do I set the TLA100 configuration setting called "Gauge Resistance, + to sender:" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3255 times since Mon, Jun 25, 2012
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.