Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

Can I use the TLA100 if I don’t have a rectangular tank?

Article Number: 80 | Rating: Unrated | Last Updated: Sun, Jul 12, 2015 11:44 PM

Yes, the TLA100 can be custom configured with up to 16 calibration points to accommodate irregularly shaped or odd shaped tanks.

Attachments

Attachments

There are no attachments for this article.

Related Articles

I know that the TLA100 uses resistive tank sensors; who manufactures resistive tank sensors?

Viewed 2158 times since Mon, Apr 20, 2009

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Operating Mode:"; what is this?

Viewed 2052 times since Thu, Jun 19, 2008

How do I set the TLA100 tank capacity using Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 2562 times since Mon, Jun 25, 2012

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Capacity:"; what is this?

Viewed 2144 times since Thu, Jun 19, 2008

How do I display the TLA100 tank remaining on Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 2305 times since Fri, Jun 20, 2008

What are the voltage specifications for each Maretron device?

Viewed 5026 times since Thu, Dec 22, 2011

How do I perform a quick setup of a TLA100?

Viewed 244 times since Tue, Apr 23, 2019

How do I set the TLA100 operating mode using Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 2218 times since Fri, Jun 20, 2008

If the TLA100 is connected and configured to operate in the "NMEA 2000" mode (i.e., without an analog gauge), how do I connect the wires to the resistive sensor?

Viewed 1521 times since Fri, Jun 20, 2008

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Reset Factory Defaults"; what is this?

Viewed 1904 times since Fri, Jun 20, 2008

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.