Knowledge Base
Home » Categories » Tank Monitoring » TLA100

If the TLA100 is connected and configured to operate in the "NMEA 2000 & Analog Gauge" mode, how do I connect the wires to the back of the analog gauge?
Article Number: 77 | Rating: Unrated | Last Updated: Sun, Jul 12, 2015 11:42 PM

You connect the TLA100 operating in the NMEA 2000 & Analog Gauge mode to the gauge in the following way:

  1. connect the black wire to the gauge ground terminal
  2. connect the green wire to the gauge sensor terminal
  3. connect the red wire to the gauge power terminal.
Posted - Sun, Jun 22, 2008 8:47 PM. This article has been viewed 2236 times.
Filed Under: TLA100
Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
What is a TLA100?
Viewed 2906 times since Thu, Jun 19, 2008
Can I set the TLA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2272 times since Fri, Jun 20, 2008
How do I perform a quick setup of a TLA100?
Viewed 930 times since Tue, Apr 23, 2019
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Reset Factory Defaults"; what is this?
Viewed 2241 times since Fri, Jun 20, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Number:"; what is this?
Viewed 2855 times since Thu, Jun 19, 2008
What firmware changes have taken place on the Maretron TLA100?
Viewed 2606 times since Tue, Oct 15, 2013
If the TLA100 is connected and configured to operate in the "NMEA 2000" mode (i.e., without an analog gauge), how do I connect the wires to the resistive sensor?
Viewed 1866 times since Fri, Jun 20, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Type:"; what is this?
Viewed 2972 times since Sun, Jun 22, 2008
How do I display the TLA100, TLM100, TLM150, or TLM200 tank capacity on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3010 times since Fri, Jun 20, 2008
How do I display the TLA100 tank level on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2880 times since Wed, Jul 9, 2008
  • Icon SubscriberSubscribe to Article
  • Icon PrinterPrint Article
  • Icon EmailEmail Article to Friend
  • Icon PDFExport to PDF
  • Icon MS-WordExport to MS Word
0 (0)
Article Rating (0 Votes)
Rate this article
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.
 
Copyright© 2019 Carling Technologies. All rights reserved. Visit Carling Technologies, a partner company.