Knowledge Base
Home » Categories » Tank Monitoring » TLA100

If the TLA100 is connected and configured to operate in the "NMEA 2000" mode (i.e., without an analog gauge), how do I connect the wires to the resistive sensor?
Article Number: 76 | Rating: Unrated | Last Updated: Sun, Jul 12, 2015 11:42 PM

You connect the TLA100 operating in the NMEA 2000 mode (i.e., without analog gauge) to a resistive sensor in the following way:

  1. connect the black wire to the sensor ground terminal
  2. connect the white wire to the sensor positive terminal.
Posted - Fri, Jun 20, 2008 12:13 PM. This article has been viewed 1504 times.
Filed Under: TLA100
Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200 and DSM250 displays have TLA100 configuration settings called "Gauge Resistance, + to sender:" and "Gauge Resistance, - to sender:"; what are these?
Viewed 2510 times since Mon, Jun 25, 2012
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Type:"; what is this?
Viewed 2469 times since Sun, Jun 22, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Reset Factory Defaults"; what is this?
Viewed 1893 times since Fri, Jun 20, 2008
How do I set the TLA100 configuration setting called "Gauge Resistance, + to sender:" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2223 times since Mon, Jun 25, 2012
What are the voltage specifications for each Maretron device?
Viewed 4976 times since Thu, Dec 22, 2011
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 1822 times since Fri, Jun 20, 2008
Can I do a custom calibration for non-standard resistance sensors or odd shaped tanks?
Viewed 2128 times since Thu, Jun 19, 2008
Why doesn’t my tank display doesn’t read full when the tank is full?
Viewed 1829 times since Thu, Jun 19, 2008
How do I set the TLA100 configuration setting called "Gauge Resistance, - to sender" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2267 times since Fri, Jun 20, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Capacity:"; what is this?
Viewed 2113 times since Thu, Jun 19, 2008
  • Icon SubscriberSubscribe to Article
  • Icon PrinterPrint Article
  • Icon EmailEmail Article to Friend
  • Icon PDFExport to PDF
  • Icon MS-WordExport to MS Word
0 (0)
Article Rating (0 Votes)
Rate this article
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.
 
Copyright© 2019 Carling Technologies. All rights reserved. Visit Carling Technologies, a partner company.