Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

I know that the TLA100 uses resistive tank sensors; who manufactures resistive tank sensors?

Article Number: 75 | Rating: Unrated | Last Updated: Sun, Jul 12, 2015 11:41 PM

To find manufacturers who provide resistive tank senders compatible with the TLA100, search the internet for these terms: fuel and sender, or try these web sites:

Attachments

Attachments

There are no attachments for this article.

Related Articles

Can I use the TLA100 if I don’t have a rectangular tank?

Viewed 1532 times since Thu, Jun 19, 2008

What type of tank senders does the TLA100 work with?

Viewed 2186 times since Fri, Jun 20, 2008

Why doesn’t my tank display doesn’t read empty when the tank is empty?

Viewed 1739 times since Sun, Jun 22, 2008

Why doesn’t my tank display doesn’t read full when the tank is full?

Viewed 1769 times since Thu, Jun 19, 2008

What firmware changes have taken place on the Maretron TLA100?

Viewed 2184 times since Tue, Oct 15, 2013

If the TLA100 is connected and configured to operate in the "NMEA 2000 & Analog Gauge" mode, how do I connect the wires to the back of the analog gauge?

Viewed 1754 times since Sun, Jun 22, 2008

Why can’t I find a particular TLA100 tank level for display on Maretron’s DSM150, DSM200, or DSM250?

Viewed 2142 times since Fri, Jun 20, 2008

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Type:"; what is this?

Viewed 2395 times since Sun, Jun 22, 2008

Can I set the TLA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 1855 times since Fri, Jun 20, 2008

Using N2KAnalyzer, how do I recover a Maretron device?

Viewed 1895 times since Thu, Dec 22, 2011

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.